Hi everyone! I’m exploring whether Rample could support custom firmware—particularly a four-voice synth using DSP from Mutable Instruments’ open-source Plaits, with one voice per output and the four CV/gate pairs controlling pitch and triggering.
I’ve done some initial analysis of an older firmware image, but there are still hardware details to
confirm. Has anyone explored this already?
- MCU: Does anyone know the exact STM32 part number and its flash/RAM capacity?
- PCB photos: Are there clear photos of the inward-facing sides of both boards, or any schematics,
pinouts, or teardown notes? - Debug access: Has anyone identified SWD pads or connected an ST-Link? Is read-out protection
enabled? - Backup and recovery: Has anyone successfully backed up the complete flash, including the bootloader?
Is there a documented recovery procedure if an experimental application won’t boot? - Firmware updates: Does the SD-card updater accept custom application images, or does it require a particular header, checksum, or signature? Has anyone documented the format?
- DAC and outputs: What DAC does Rample use? Are all four individual outputs DC-coupled, and is the mix output summed in analog hardware?
- CV inputs: Does anyone know the input circuitry, filtering, and practical resolution? Has anyone
tested their accuracy and stability for 1 V/oct pitch control? - Hardware mapping: Has anyone mapped the MCU pins for the DAC, CV inputs, gates, controls, display, MIDI, and SD card?
- Existing projects: Are there any custom firmware experiments, effect patches, or open-source drivers worth building on?
- Squarp’s position: Has Squarp shared any guidance on community firmware, hardware documentation, or preserving the stock bootloader?
Any partial answers or pointers would be welcome. This is an exploratory project, not a finished port;
I’m hoping to establish what’s feasible before flashing anything.