As the title says, it appears the Hapax isn’t sending PC messages at all to the midi out port.
-
I have tried sending PC messages to both my Maschine+ and Dreadbox Nymphes. Neither units registered any incoming PC that I could tell. I made sure to check the settings on both.
-
This happens no matter how I try to send PC messages. I have tried doing this in the track settings and via PC automations, with no luck.
Is this a new issue? I do remember successfully sending PC messages to my Nymphes, but that was at least several months ago.
No PC messages are showing in the debug screen
Have you set the correct LSB and MSB values for your PC messages? I’m using PC messages all the time on my midi out ports without a glitch.
Are your devices set to receive PC messages?
Hello!
I’m controlling my Prophet-6 with the Hapax (firmware 1.13) via the MIDI USB host port (also tried via DIN MIDI). I’m using PC via the track setting to select the prophet’s preset and it’s working fine (MSB and LSB as well). As I understand PCs are linked to a pattern and sent only when the pattern is enabled. They are also sent when you set the PC on a particular pattern, which in my opinion can be a bit annoying as it immediately changes parameters on the connected synth. Maybe there could be an option to enable/disable this behaviour?
I didn’t try to send PC via automations though.
And I don’t see an option to enable/disable sending PCs in the settings menu. It should work out of the box, maybe the solution is in Maschine+ or Breadbox’s setting?
The Dreadbox Nymphes does not use LSB or MSB. I don’t think the Maschine+ does either, but I could be wrong.
I said in my original post that I did.
