CC in automation / assing is limited to #119

Hapax Instrument Definitions
1

You would say “RTFM” but I realised after dealing with a syntax error that it’s stated:

For CC: Value must be a valid number between 0 and 119

and that’s both or AUTOMATION and ASSIGN.

not sure why… but anyway keep it in mind if you have a parameter whose CC is > 119… you are not able to add that automation lane

2

this is actually part of the midi spec. cc above 119 are reserved for special stuff

1 Like
3

I see! I was trying to map the automation lane of the LXR-02 and there are some messages controllerd by these numbers… Well i will live without :smiley:

Also fun that you can define them in the CC list but not in the ASSIGN

4

manufacturers dont always pay attention to those limits

1 Like