# One encoder seems to jump around **URL:** \ **Category:** Hapax\ **Created:** [September 5, 2026, 7:41pm UTC](https://squarp.community/t/one-encoder-seems-to-jump-around/16422 "2026-09-05T19:41:50Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![dhaworth](https://squarp.community/letter_avatar_proxy/v4/letter/d/ecc23a/32.png) [@dhaworth](https://squarp.community/u/dhaworth)\ **Post date:** [September 5, 2026, 7:41pm UTC](https://squarp.community/t/one-encoder-seems-to-jump-around/16422/1 "2026-09-05T19:41:50Z")
Anybody a have an issue with one or more encoders jumping values when turned? Mine is specifically the top-right encoder (encoder #7?), the one which controls note length. IE if it’s set to one, and i turn it CW one click, and it jumps to 7 or 9 or 16. Turning to the left seems to work properly, Ie one click = one increment. I booted into test mode but that just confirmed the rotators worked, not their calibration. ?? OS 3.10 ---
**Author:** ![solipsvs](https://squarp.community/user_avatar/squarp.community/solipsvs/32/2566_2.png) [@solipsvs](https://squarp.community/u/solipsvs)\ **Post date:** [September 5, 2026, 8:18pm UTC](https://squarp.community/t/one-encoder-seems-to-jump-around/16422/2 "2026-09-05T20:18:32Z")
give it like 50 rapid turns in both directions ---
**Author:** ![dhaworth](https://squarp.community/letter_avatar_proxy/v4/letter/d/ecc23a/32.png) [@dhaworth](https://squarp.community/u/dhaworth)\ **Post date:** [September 6, 2026, 6:50pm UTC](https://squarp.community/t/one-encoder-seems-to-jump-around/16422/3 "2026-09-06T18:50:32Z")
Thank you for responding, after I posted I actually found your post describing the exact same problem 🙂 Unfortunately doing the 50 turns both ways didn’t fix it for me ☹ I even spryed soem air in there, no beans. I’m gonna contact Squarp and see if I need a new encoder.