Default parameters for each CC

Hapax
1

Hi,

I’m a bit unable to understand: I tried setting all the parameters of me BD on my Jomox Airbase 99 with default values for each CC. But when changing the drumkit it was not the same sound.

I tried doin a stop/start on Hapax to re-send default values, then trying to create an automation line with a value on 1st step.

I precise that ALL parameters of the BD are CC controlable, so changing the drum kit should not make any change once it is setted by CC but it does

So anyone knows why

Thanks

2

Ok I did some tests but I feel like the problems comes from the fact Hapax is not sending the datas with they don’t change.

I would personnaly like the default value to be sent at least after a stop/start. And maybe more at every pattern start. And same for fixe automation value

Any possibility to do that ?

Cause in this exemple it is much faster for me to edit Jomox parameters with default values on Hapax than with the small screen. And then later I’m already on good values to edit them with anything

3

I did some test again to make a pattern change but it doesn’t send the default values.

I have to edit them one by one if I want them to be sent it’s a bit boring there must be a solution ???